Arduino Fans

Description

Micro USB 5V 1A 18650 Lithium Battery Charger Module TP4056 Charging Board With Protection Dual Functions 1A Li-ion Charger

• 100% New and High Quality Micro USB TP4056 Dual Charging Module
• Input Voltage: 4.35V – 6V (recommended voltage 5v)
• Charging cut-off Voltage: 4.2V (± 1%)
• Maximum Charging Current Output: 1000mA (1A)
• Battery Discharge Protection Voltage: 3.0V
• Charging Status LEDs: Red LED Charging, Green LED Fully Charged
• Note: The installation and usage of these modules require some basic knowledge of electronics, if you don’t know how to install, please don’t buy it.

The first time you access the battery, it may no voltage between the output OUT + and OUT-, then access 5V voltage charge your energy can activate the protection circuit, and the battery from the B + B-, then draw a line on the short open also need recharged to activate the protection circuit.Note that the charger must be able to output 1A or more to do when using a mobile phone charger input, or may not charge

+ MICRO USB female and next – pads for the power input, access 5V.B + positive then the lithium battery, B- then negative lithium batteries.OUT + and OUT- connected to the load, such as positive and negative electrodes connected mobile booster plate or other load.
Connect the battery to the B + B-, inserted into the USB female mobile phone charger, the red light is being charged, the green light to full.

The charge should disconnect the load OUT terminal on the positive and negative can not be wrong, please according to specifications, otherwise it will damage directly.

The charge should disconnect the load OUT terminal on the positive and negative can not be wrong, please according to specifications, otherwise it will damage directly.

Disclaimer:

• Inputs with MICRO USB female, can be directly input to do with the phone charger rechargeable lithium battery,
• And still retains the input voltage wiring pads, can be very convenient DIY
• Input voltage: 5V
• Charging cut-off voltage: 4.2V ± 1%
• Maximum charge current: 1000mA
• Battery over-discharge protection voltage: 2.5V
• Battery over-current protection current: 3A
• Board size: 2.6 x 1.7cm